How do you tie baseball glove laces?
Start at the heel or palm and thread the lace through the matching holes, keeping the ends even. Work outward, pull each section snug and cross the ends where the pattern requires. Finish with a secure knot and trim excess lace. Check the glove's original pattern before removing old laces.
Last updated
- Photograph the old lacing before removing it.
- Use a lace long enough to finish the knot.
- Pull sections snug but not tight enough to pucker.
- Trim excess and melt synthetic lace ends safely.
Myth: a snapped lace is a reason to replace the glove
A lace breaks, the web droops, and the glove suddenly feels like a different piece of equipment. Replacement parts are ordinary: Rawlings lists a Pro Glove Re-Lace Pack at US$24.99, Black and Tan Glove Lace Kits at US$4.95 each, and an Eye-Type 5 in (12.7 cm) Lacing Needle at US$9.95 on its US site. Relacing is maintenance, not a reason to retire the leather.
Equipment advice points the same way: the American Academy of Pediatrics calls for gear that fits and is kept in good repair. A glove with a loose web is not only a fielding problem; it changes how the glove closes and how the ball sits in the pocket.
Myth: you should pull every lace as tight as possible
Lace tension shapes the pocket. Wilson's break-in method starts by pouring warm, not boiling, water into the palm to relax the leather, then notes that the finger tops and lace will stretch and return to their original state once dry. The lace is part of a system that moves, not a rigid clamp.
Wilson also loosens the top laces before forming the pocket with a mallet. After a relace, pull each run snug enough to remove slack, close the glove, and check that the pocket still rounds out where the ball lands. A lace pulled until the leather puckers can flatten the shape you are trying to restore.
Myth: any needle and any off-cut of lace will do
Wilson's relacing guide tells the worker to poke a hole in the tip of the lace, thread it through a piano wire needle, and leave a few inches of lace for later. Rawlings sells a purpose-made lacing needle with an eye, listed at 5 in (12.7 cm), because pushing a blunt lace through old holes is the part that turns a small repair into an afternoon.
Buy lace by the kit rather than cutting a random length. Rawlings' kits come in black and tan so the repair can match the original leather, and a full kit leaves enough to finish the run and knot the ends. Keep the old lace beside the new one as a length guide.
Myth: the knot can be improvised at the end
A glove lace knot has to survive pulls in every direction. Wilson's wrist-strap walkthrough finishes by tying off the lace ends with a double knot after routing the lace through numbered holes. The same principle applies to web and pocket laces: follow the original path, keep the ends even and finish with a knot that will not creep.
Before you remove a lace, photograph the old pattern or draw it. Work one section at a time so the glove does not collapse, and keep tension consistent across neighbouring runs. When the repair is done, squeeze the glove closed and open it a few times; if the web pulls crooked, one run is tighter than the rest.
Frequently asked questions
How long should replacement glove laces be?
Long enough to follow the full path plus a few inches left over for the knot, which is why Wilson's guide tells you to leave extra lace rather than trimming early. A pre-cut lace kit removes the guesswork; if you buy bulk lace, compare it with the piece you removed before cutting.
Can I relace the glove myself, or should a shop do it?
Rawlings sells lacing needles and lace kits for home repair, so a patient adult can handle a single section. A full relace of every hole takes longer and is easy to get wrong on the first try. Start with the broken run, photograph the pattern, and stop if the leather around the holes is cracking.
How tight should glove laces be when I finish?
Snug, not crushing. Pull out the slack, then close the glove and watch the pocket: the leather should round into a catchable shape rather than pucker flat. Wilson loosens top laces before shaping a pocket, which shows tension is a tuning adjustment, not a test of strength.
Do new laces change how a glove feels?
Yes, briefly. Wilson notes that lace and finger tops stretch when wet and return to their original state once dry, so a fresh relace can feel stiff for a few sessions. Play catch, let the glove move, then re-check the knot and the tension on the run you replaced.
Sources
Baseball questions · Find a baseball team
Running a club or league? See software to run a sports club, alternatives to the big team apps, free round robin generator, or build a tournament online.
Open Next Play