Sets and reps are the dials you turn every session, so it is worth getting them roughly right. The good news is that research gives a wide target rather than one magic number. Muscle grows across a broad range of reps as long as sets are hard and there are enough of them across the week. The picker above gives a starting point for six common situations: building muscle, building strength, endurance, complete beginners, people short on time, and people returning after a break. Below is how those recommendations are worked out and how to adjust them for yourself.
On this page
Reps: the range that works
A review by Schoenfeld, Grgic, Ogborn and Krieger (2017) found that low-load training (more than about 15 reps) and high-load training (fewer than about 8 reps) produced similar muscle growth when sets were taken close to failure, while heavier loads produced greater gains in maximal strength. In practice:
| Reps per set | Main effect | Notes |
|---|---|---|
| 1-5 | Maximal strength | Long rests, technical lifts |
| 6-12 | Muscle and strength | Efficient middle ground |
| 12-20 | Muscle and endurance | More fatigue, lighter loads |
| 20+ | Endurance | Hard to judge failure accurately |
Most people put the majority of their muscle-building sets in the 6 to 15 range because it balances load, time and fatigue.
Sets: per exercise and per week
Per exercise, 2 to 4 sets is typical. What matters more is the weekly total per muscle. A dose-response meta-analysis by Schoenfeld, Ogborn and Krieger (2017) linked more weekly sets with more growth, with 10 or more per muscle per week a commonly cited target. Many programmes sit between 10 and 20.
Effort: reps in reserve
Reps in reserve (RIR) is how many more reps you could have done. Finishing sets at 0 to 3 RIR keeps them productive without wrecking recovery. If you finish 12 reps and could easily have done 20 more, the set did little.
Worked example
These are example inputs. You want about 12 weekly sets for chest and train upper body twice a week.
- Session 1: bench press 3 x 8, incline dumbbell press 3 x 10 = 6 chest sets
- Session 2: machine chest press 3 x 12, push-up 3 x as many as possible with 2 in reserve = 6 chest sets
- Weekly total: 12 sets
Progress with a double progression: when you hit the top of the rep range on all sets (for example 3 x 10 on incline press), add the smallest weight step and drop back to the bottom of the range.
How to use the picker above
- Pick the goal that best describes you.
- Read the starting sets, reps and rest.
- Use it for four to eight weeks, logging each session.
- Adjust: if you recover easily and progress stalls, add a set; if you feel run down, remove one.
Rest between sets
Longer rest, around 2 to 3 minutes, generally helps you keep performance up on heavy compound lifts. For isolation exercises, 60 to 90 seconds is usually enough. A study by Schoenfeld et al. (2016) found longer rest periods supported greater muscle growth than one-minute rests in trained men.
If you have an injury, medical condition or are under 18, check with a doctor or qualified professional before increasing training load. General fitness information, not medical advice.
Adjusting sets and reps over time
Start at the lower end of the weekly range, around 10 sets per muscle, and run it for four to six weeks. If your lifts are still climbing and you recover well between sessions, keep it there. If progress stalls and you feel fresh, add one or two sets per muscle per week. If you feel worn down, sleep poorly or your lifts drop, reduce sets for a week, often called a deload, then build back up. Change one variable at a time so your log shows what made the difference.
Log it in your free athlete profile
A free P2ES athlete profile includes a workout log where you record each set's weight and reps, which makes double progression easy to follow. It is free.
Questions
It can be, depending on weekly totals. Three sets of 10 on one exercise, done twice a week, gives 6 weekly sets for that muscle. Adding a second exercise or a third session would bring it into the 10 to 20 range commonly cited in research. Effort matters too: sets should end close to failure.
Both can work. Research by Schoenfeld et al. (2017) found similar muscle growth from light and heavy loads when sets were close to failure. Heavier loads build more maximal strength. Most people use moderate reps, roughly 6 to 15, for most sets because they balance effort, time and joint stress.
One to three exercises per muscle per session is typical. Beginners often do well with one; more advanced lifters may use two or three to reach their weekly set target and train the muscle from different angles. Count weekly sets rather than exercises.
Around 2 to 3 minutes for heavy compound lifts such as squats and presses, and 60 to 90 seconds for isolation exercises, is a common recommendation. Longer rest lets you lift more on the next set. If time is short, pair non-competing exercises as supersets.
Not usually. Going to total failure on every set adds fatigue and can reduce performance on later sets. Most coaches suggest stopping with 0 to 3 reps in reserve, and saving true failure for the last set of safer exercises such as machines or curls.
A simple method is double progression: pick a rep range such as 8 to 12, and when you can complete all sets at the top of the range with good form, add the smallest weight increment and start again at the bottom of the range.
General fitness information, not medical advice. Talk to a doctor or qualified professional before changing your training or diet, especially with a health condition, an injury, during pregnancy or under 18.
